Programming the SIB™
Introduction SiB™ vs SID mode Programs in SiB™ mode Programs in SID mode Sample Programs - Door Bell - Emergency Button - Freezer Monitor - I Love You - Lights Demo - Magnetic Alarm - Motion Sensor - Sweet Dreams - Thermometer - Water/Moisture Sensor - Yes or No Commands A - Z Configuration GPIO Programming Time Sensor Messaging | Sample Programs: Motion Sensor The motion sensor app uses a motion sensor accessory. The motion sensor can operate while the SiB is sleeping, and uses one of the SiB's GPIO's to wake the SiB when motion is felt. The sensor is initialized over I2C. FN startmotion ; define a function to start motion detection iic off ; disable IIC in case it was already on wd 4 0 ; power off the sensor to perform a reset wd 13 0 dl 100 ; allow a 100ms break for the sensor reset iic on 26 25 200000 1 ; intiialize I2C on GPIO 26 and 25 ; at 200000 bits per second ; with software pull-up enabled hold 13 1 ; power the sensor EVEN when the SiB is sleeping dl 100ms ; allow the sensor time to power on wd 4 1 ; enable the sensor ; initialize the sensor ; note the <0> - represents a parameter for sensitivity ; from 00 to FF iic seq bw18+21+03+pbw18+28+<0>+pbw18+27+02+pbw18+16+07+pbw18+17+00+pbw18+1b+04+pbw18+19+04+p ; the sensor is ready and operating. The SiB will ; go to sleep and wake when GPIO 34 is set to high by the sensor. wakeio 34 1 ; main program PROG alarm startmotion 80 imto 12345551234 MOTION DETECTED! LoopTO SUBMIT THIS PROGRAM: First, send MODE SID to your SiB, as this is a SID program. It is not activated by the button press but rather by a sensor Next, send the funciton (FN) in an IM to your SiB Next, send the program (PROG) in an IM to your SiB Finally, press your SiB to receive all instructions.! |