Programming the SIB™
Introduction SiB™ vs SID mode Programs in SiB™ mode Programs in SID mode Sample Programs - Door Bell - Emergency Button - Freezer Monitor - I Love You - Lights Demo - Magnetic Alarm - Motion Sensor - Sweet Dreams - Thermometer - Water/Moisture Sensor - Yes or No Commands A - Z Configuration GPIO Programming Time Sensor Messaging | Introduction The SiB™ is programmed via sequences of short commands, sent via IM. While many commands can be sent to the SiB™ to run immediately, like "TEMP" to read the temperature, other commands can only be used in specific sequences to make up a "program". The SiB™ can store multiple programs at the same time, and run programs in a variety of ways: - upon pressing the button - after a specific sequence of button presses (example: short short short long) - on a timed loop (example: every 20 minutes) - by an external sensor - by a messaged command |